Calculators · Consumption

Fastener calculator

Exact quantity from the supplied rule, reserve, and package purchasing. Normative fastener selection is not performed.

Quantity and composition come from the entered layout. If the same physical connection is entered more than once, use the same ID and identical parameters.

Node 1

Result

Procurement arithmetic

Procurement quantity—
Net required—
Waste—
Procurement quantity—
Packages—
Surplus—

Estimate by area — estimate from the entered rate, not a geometric layout or code-based consumption rate. No mode in this calculator verifies connection load capacity.

Calculation trace and data sources
Calculation technical data

Fasteners: method and scope

What it calculates

The calculator retains the area-rate estimate and adds geometric layouts for profiled sheets and boards, plus connection quantities by node. Layout reports fastening points and procurement; Connections reports the selection status for each node.

Inputs and units

For profiled sheet, enter the exact model, useful width, thickness, corrugations or documented coordinates, supports, laps and a screw with substrate characteristics. For OSB/plywood, enter size, thickness, supports and supported edges, offsets and fastener. Connections accepts the item, substrate, layer thicknesses and applicability source. Dimensions use mm and quantities use pieces.

Calculation method

Layout computes support and joint fastening points and removes coincident physical points. Corrugation indices are not millimetre coordinates. Procurement is rounded to packages after reserve is added.

How to read the result

The result separates net requirement, reserve, requirement with reserve, package count, purchased quantity and surplus. After reserve is added, procurement is rounded up to whole packages; the intermediate fastener count is not separately rounded to an integer. Valid inputs return Core status ok; invalid values show an input validation message.

Reproducible example

Example: area 72 m², rate 6 pieces/m², 5% reserve and 250 pieces per package. Net requirement: 72 × 6 = 432 pieces; reserve: 21.6; requirement with reserve: 453.6. Procurement is ceil(453.6 / 250) = 2 packages, or 500 pieces; surplus above the reserved requirement is 46.4 pieces.

Limitations

Candidates and installation rules apply only to the stated product and source scope. VERIFIED_RULE confirms applicability of the installation rule, not screw or connection capacity. Unknown profile, item or substrate require manual verification and may be FASTENER_NOT_VERIFIED; incomplete geometry is INCOMPLETE. Estimate remains an estimate using the entered rate.

Data and provenance

Sources for EGGER OSB T&G and Grand Line C21R are shown with their exact scope. The selected fastener and substrate characteristics remain user inputs; a UI candidate is not an SKU and does not confirm strength. Defaults are UI presets, not normative requirements.