Calculators· Mass & Geometry

Mass and geometry calculators

Use this tool to check geometry and mass, calculate coating area for multiple members and estimate material quantities from product data or DFT. Coating system suitability requires separate verification.

Calculators· Mass & Geometry

Rectangular hollow section

Rectangular hollow section

Unified calculation layer

Geometry, mass and paint area

mm
mm
mm
mm
mm
mm
mm
mm
mm
m
m
m
pcs

Result

Rectangular hollow section

Total weight— kg
Cross-sectional area
— mm²
Weight 1 m
— kg/m
External surface
— m²
Internal surface
— m²
Selected paint area
— m²

Theoretical mass based on section geometry. Bending radii/fillets are not included.

Calculation details

Input data

Formulas

    Assumption

    The model uses theoretical sharp-corner geometry and material density from the current canonical material record.

    References and provenance
    • Methodologydocs/calculations/ed-p4-materials-geometry-weight-paint.md
    • Material density1lvl.thermal.materials · sp50-m1-245
    • Normative rolled-section mass and radiinot applied

    The result uses theoretical sharp-corner geometry. Normative section accuracy and table references require separate verification.

    Protective coating of steel structures

    Enter the member geometry and each coating layer from its product datasheet or specified dry-film thickness, along with application losses and package size. Blank values are not replaced with code defaults.

    Members and paintable area

    You can enter up to six members of different types and sizes. Group identical members by quantity. Closed tubes are measured on the outside; explicitly include the inside surface, end faces and additional welded area, and enter any area to exclude.

    Member 1

    For plate, enter A as length in metres and B as width in millimetres; specify thickness separately. The area includes both faces, edges and ends according to the selected options.

    Member 2

    For plate, enter A as length in metres and B as width in millimetres; specify thickness separately. The area includes both faces, edges and ends according to the selected options.

    Member 3

    For plate, enter A as length in metres and B as width in millimetres; specify thickness separately. The area includes both faces, edges and ends according to the selected options.

    Member 4

    For plate, enter A as length in metres and B as width in millimetres; specify thickness separately. The area includes both faces, edges and ends according to the selected options.

    Member 5

    For plate, enter A as length in metres and B as width in millimetres; specify thickness separately. The area includes both faces, edges and ends according to the selected options.

    Member 6

    For plate, enter A as length in metres and B as width in millimetres; specify thickness separately. The area includes both faces, edges and ends according to the selected options.

    Coating system

    A/B/C are example presets, not approved coating systems. Add a separate row for each material or coat. For system B, enter the number of primer coats separately.

    Material / layer 1
    Material / layer 2
    Material / layer 3
    —

    Shared calculation layer

    Section areas use the existing engine section geometry. Coating consumption is calculated separately from entered product data; total material requirements and pack rounding use the existing procurement engine.

    Limitations

    Mass is a theoretical geometric estimate. Bending radii and fillets, normative assortment mass, holes, weld metal and cutting optimization are not included.